Skip to main content

External Render Repairs and Plastering- North East

Specialist Render Works & Replastering

Defective render is one of the most common causes of penetrating damp — and the wrong render creates damp where there was none. We specify and carry out render and plaster work as part of a building's moisture management.

When render is the problem

Render fails in ways that are easy to see and easy to misread:

  • Cracking — hairline crazing through to structural cracking, allowing water directly into the substrate

  • Blown or hollow sections — render that's lost its key, usually found by tapping rather than by eye

  • Sulphate attack — expansion and cracking where sulphates in the masonry react with cement render

  • Cement render on solid walls — traps moisture in a wall that needs to breathe, and is a frequent cause of internal damp in older property

  • Bridged DPC — render carried down over the damp proof course, giving moisture a direct route past it

  • Failed coatings — sealants and waterproof paints applied over damp render, holding moisture in

Replastering after damp proofing

The replastering is what makes a chemical damp proof course work. Get it wrong and the DPC is irrelevant — salts continue to migrate, the finish blows, and the guarantee is worthless.

We replaster to PCA standards: correct mix and additives, correct height above the treated course, correct sequence and drying times, and no gypsum where it doesn't belong. Where a breathable specification is more appropriate, we'll say so.

Specialist Render Systems

External render repair and renewal — cracked, blown, hollow or delaminating render, failed pebbledash, sulphate attack and moisture trapped behind sealed coatings. We cut out and make good, or strip and re-render where the substrate demands it.

Breathable lime render for solid wall and traditionally-built properties, where cement render prevents the wall drying and drives moisture inwards.

Through-coloured and thin-coat systems, silicone and acrylic renders, monocouche and traditional sand and cement.

Full reinstatement — hack off, beads, plastering, skirtings and making good, so the job is finished properly rather than handed back to another trade.

Who we work for

Local authorities, housing associations, national companies, letting and estate agents, builders and private homeowners. Work ranges from single-room reinstatement following damp treatment through to multi-property programmes and full refurbishment.

 

This product has been added to your cart

CHECKOUT